FAQ How to use 4g wireless tracker correctly?

4g wireless tracker https://www.eelinktracker.com/4G-GPS-Tracker/

After sorting out so many consultation messages from the background, Xiaobian summarized a phenomenon: for such electronic products as 4g wireless tracker, everyone is most willing to see the answer to questions and science and good Amway. So today Xiaobian has sorted out some of the questions we often ask, and offered today's Q&A

In the daily use of 4g wireless tracker, the following situations are believed to have been encountered by most people. Let's see what potholes you stepped in.

First pit: The position either cannot be refreshed or there is a delay. In this case, we should first make sure that the 4g wireless tracker is not in a bad signal (such as the basement, etc.) or there is a signal interference source (such as closed metal space, etc.). If this is the case, then drive the car out in the open and see if you can read the data properly. In addition, if the device is just started, it is normal to have a little delay, and the car will drive in the open area for a minute or two.

Second pit: GPS positioning platform and APP display LBS base station positioning. GPS positioning terminals are based on two positioning modes, namely GPS positioning and LBS positioning. The display of the platform does not mean that the device is faulty, LBS positioning is what we call the base station positioning, and LBS will be enabled for positioning when the GPS positioning terminal signal is weak. The principle is to obtain the location information of the mobile end user (the Internet of Things card in the device) through the mobile operator's network (GSM network) through telecommunications, and the accuracy of the location information depends on the coverage density of the base station around the vehicle. It can be understood as a "relay measure". The reason for such a situation is that the device is in a bad signal or is shielded from interference as mentioned above.

Third pit: Ultra-long standby positioning terminal upload data is not real-time data. The working mode of the GPS positioning platform periodically reports the position information of the ultra-long standby positioning terminal. If you do not deliberately set, the general locator will have a default time to report information. So you can set the location information for how long you want in the background.

4g wireless tracker https://www.eelinktracker.com/4G-GPS-Tracker/


Comments